VIA und USO handset with flat tabletop mount and weighted cable retraction

To ensure the installation and optimal use of the handset with angled tabletop mount and weighted cable retraction, there are parameters that need to be considered and taken into account beforehand. durch Gewicht zu gewährleisten, gibt es Parameter die im Vorfeld zu beachten und bedenken sind.

Usageposition

• Consider in advance whether you will be using the receiver primarily while sitting or standing. This will affect the installation and usability.

Cable length (cable protection sleeve)

• The maximum extendable cable length is approximately 90 cm. This should be considered in relation to the height of the mounting surface (e.g., the height of the furniture). The cable protection sleeve has a total length of 125 cm. Further details can be found in the quick guide in the download section.
• Test the extendable cable length to ensure it is sufficient for your usage position (sitting or standing). The weight on the cable protection sleeve should be positioned within the furniture according to the desired extendable length.

 Mounting area

• Choose an easily accessible position for the receiver holder. Ensure that there is a free space of at least 20 × 20 × 65 cm (width × depth × height) beneath the position of the receiver holder in the furniture to accommodate the receiver cable/protection sleeve, including the weight

Surface inclination

• The handset can be used without interference on a surface inclined up to 20°.

See the quick guide for “VIA/USO table mount with weight” in the download section

 

VIA and USO handset and spring-loaded cable retraction with roll guide

To ensure proper installation and optimal use of the single-handed receiver with a table mount and spring-loaded cable retraction, and to find its individual placement, you need to consider the following criteria. The placement within your furniture depends on its dimensions.

Usageposition

• Consider in advance whether you will predominantly use the handset while sitting or standing. This will affect the installation and usability.
• All units must be positioned as close to each other as possible to ensure that the diagonal distance for the hand device cable is as long as possible.
• The flex hose of the single-hand receiver, the steel cable, and the balancer must be aligned with the deflection pulley so that the cable always runs on the same plane (in most cases, about 8 cm / 3.15″ from the back wall or the wall near the cable entry).

See the detailed quick guide for “USO Tischhalterung und federbelastendem Kabelrückzug mit Rollenführung DE EN” in the download section.

The picture shows a general arrangement.

Mounting units:
a. handset
b. handset table-stand
c. Cable guide with angle guard
d. Cable Stopper
e. Pulley Guide-Wheel
f. Spring-Retraction Pulley with original Accessories

Positioning in furniture:
Prior to beginning assembly, it is necessary to determine the positions of the Handset Stand and Cable Guide (A), Pulley Return Guide (B) and Spring Loaded Retraction Pulley (C).
Important note: The cable and pulley system must all run along the same plane in the furniture to ensure it runs
smoothly. Ensure the cable enters the cable guide and guard at an angle that does not cause it to
rub against the cable guard. This will cause increased noise and wear on the cable when used.

• Considerations for the assembly Positions (A-C)
  • A The cable entry at the Table-Stand
  • Individual length of the Handset cable with flexible steel casing
  • Maximum cable length of the retractionpulley (1.6m)
  • Desired/Required retraction force
  • B, C Available room in the furniture for the assembly positions.

 

Possible assembly variation: handset shown fully retracted

Possible assembly variation: handset shown fully extended

Further assembly variation: handset shown fully retracted

 

(c) Cable guide with angle guard

(e) Pulley Guide-Wheel
Ø 52mm with bracket at an angle 60 x 60 x 45mm,

(f) Spring-Retraction Pulley with original Accessories

 

 

Download